Description
: Two component polyamide cured epoxy primer
Principal Characteristics
: General purpose epoxy primer in protective coating systems for steel and non ferrous metals
: Good adhesion to steel galvanized steel and non ferrous metals
: Good flow and wetting properties
: Good water and corrosion resistance
: Cures at temperature down to +5 ˚C
: Suitable for touching up of weld seams and damages of epoxy coating during construction
: Long recoating intervals are possible when overcoating with epoxy and polyutherane coatings
: Can be over coated with most alkyd, chlorinated rubber, vinyl, epoxy and two component polyutherane coatings
: Suitable on wet blast cleaned substrates (damp or dry)
: Compatible with cathodic protection system
Colours and Gloss
: Greenish yellow (redbrown on request) - eggshell
Basic data at 30 ˚C
Solid content
: approx. 57% by volume
Recommended dry film thickness
: 50-75µm depending on systems
Theoretical spreading rate
: 11.4 m2/1 for 55µm, 7.6 m2/1 for 75µm on smooth and non absorbent surfaces
Touch dry after
: 45 minutes
Overcoating interval
: minimum 8 hours
: maximum 2-4 months, provided surface is cleaned
Nozzle orifice
: 1.5 - 2mm
Nozzle pressure
: approx 3-4 kg/cm2; 43-57 psi